Vimar 40510 Guide Rapide page 21

7" Due Fili Plus porter switchboard: 40510
End conversation
To end the conversation, carry out one of the following actions:
• Press key
• Hang up the handset (if the conversation took place via the handset)
Putting a call on hold and transferring a call
Press key to put the indoor or speech unit involved in the conversation on hold temporarily. The device previously
involved in the conversation will emit a specific tone as notification of its on-hold status. While on hold, if the handset is hung
up, the call is not ended. Press key
A second call can be started while the first call is on hold: enter the number you wish to call, then press the
or lift the handset (hang up and lift again if it was already in use). Also, while a conversation is taking place, enter a number
and press the key to automatically place the current conversation on hold and start a direct call to the newly entered
number.
When the switchboard is in Internal mode and receives a call from a speech unit intended for an indoor unit, after entering
into a conversation with the speech unit, that call can be put on hold and a second call made to the requested indoor unit
by pressing key , followed by
In the event of a call to a second indoor unit, after receiving an answer, the switchboard can place the two indoor units in
a conversation with one another. Press key
Lock
Press and release the
place. In standby, the command is sent to the last speech unit which was contacted or which called.
Dial a number and then press the
Dial a number and then hold pressed the
sponding to the number dialled.
Press and hold for 0.5 seconds; if programmed, the activation menu opens. If the menu is not programmed, a
warning tone is emitted. Select the desired activation from the list using the
key to carry out the activation, or
The key also works in the same way during conversation with the speech unit.
again to resume the conversation.
.
to transfer the call.
key to send the open lock command to the speech unit with which conversation is taking
key to send the command to the speech unit corresponding to the number dialled.
key for 0.5 seconds to send the activation command to the relay corre-
to exit the menu. The menu also closes in the event of prolonged inactivity.
and
EN
key
keys. Then press the
21