Unable To Complete Adaptiq Audio Calibration With Your Soundtouch 300 Soundbar; Error Message - Bose MODULE 500 Mode D'emploi

UNABLE TO COMPLETE ADAPTIQ AUDIO CALIBRATION
WITH YOUR SOUNDTOUCH 300 SOUNDBAR
If you can't complete ADAPTiQ audio calibration with your SoundTouch 300 soundbar,
listen to the voice prompts for the following error messages:

ERROR MESSAGE

1
2
3
4
5
After correcting your problem, you must run ADAPTiQ audio calibration again
(see page 15).
If you hear a different error message, contact Bose customer service for further
instructions.
TR OUBL ES H O OTI N G
PROBLEM
The microphone on
the ADAPTiQ headset
can't detect sound.
The room is too loud.
The ADAPTiQ headset
is too close to the
speakers.
The listening locations
are too similar.
The ADAPTiQ
headset cannot take
measurements due
to movement.
2 6
WHAT TO DO
a connector.
Secure all cables.
Disconnect the ADAPTiQ headset cable
and reconnect it firmly into the soundbar's
Ensure the microphone opening on the top
of the ADAPTiQ headset is not blocked.
Your ADAPTiQ headset may be damaged.
Call Bose customer service for
replacement parts.
Re-run ADAPTiQ audio calibration when the
room is quiet.
Move the ADAPTiQ headset farther away
from the speakers.
Move 1 – 2 ft. (0.3 – 0.6 m) away from your
previous listening location.
Hold your head still.
|
E N G