Kohler Tea-for-Two K-856-V-0 Guide D'installation Et D'entretien page 10

Heater On/Off
Power
Lighted User Keypad
(for whirlpools
without neckjets)
Operating Instructions
All Models
NOTE: A built-in heater helps to maintain the water temperature when the whirlpool is running. If the
temperature exceeds 104°F (40°C), the heater will turn off.
Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully
counterclockwise.
Fill the whirlpool to a water level at least 2" (51 mm) above the top of the highest jet.
Press the Power icon to turn on the whirlpool. The whirlpool will start at medium flow, and the
heater will turn on automatically.
Adjust the water flow by pressing the up or down icon on the keypad. An indicator bar in the
center of the keypad shows the water flow volume.
Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow,
and counterclockwise to increase the air flow.
Press the heater icon to turn the heater off and on. When illuminated, the indicator light shows that
the water temperature will be maintained up to 104°F (40°C).
Press the Power icon a second time to turn the whirlpool off.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
Models with Neckjets
Make sure the slip cover is in place on the pillow, and the pillow is attached to the neckjet body.
1199250-2-A
Heater Indicator Light
Up
Indicator Bar
Down
Flexjet
Mode
Backjet
Mode
Rotate outer
ring to access
desired mode.
Power
Chromatherapy -
Specific Color
Neckjet
Mode
Up
Lighted User Keypad
10
Turn jet trim
clockwise to
decrease the flow.
Turn jet trim
counterclockwise
to increase the flow.
Indicator
Bar
Effervescence
Mode
Down
Chromatherapy
Cycle
Heater
Kohler Co.