Unpack The Machine; Install The Battery Pack; Remove The Battery Pack; Install The Upper Handle - GreenWorks Pro SNC404 Manuel D'opérateur

WARNING
Do not connect to power supply until you assemble all
the parts.
6.1

UNPACK THE MACHINE

WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
6.2

INSTALL THE BATTERY PACK

2
WARNING
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the engine stops
before you install or remove the battery pack.
• Read, know, and follow the instructions in the
battery and charger manual.
1. Open the battery door(1).
2. Align the ribs on the battery pack(2) with the
grooves in the battery compartment.
English
3. Push the battery pack(2) into the battery
compartment until the battery pack(2) locks into
place.
4. When you hear a click, the battery pack(2) is
installed.
5. Close the battery door(1).
6.3

REMOVE THE BATTERY PACK

1. Open the battery door(1).
2. Push and hold the battery release button(3).
3. Remove the battery pack(2) from the machine.
6.4

INSTALL THE UPPER HANDLE

1. Align the holes in the middle handle and the upper
handle.
2. Put the bolts(2) through the holes.
3. Tighten the handle knobs(1) onto the bolts(2).
4. Do the same operation on the other side.
1
6.5

INSTALL THE MIDDLE HANDLE

3
1. Align the holes in the middle handle and the lower
handle.
2. Put the bolts(1) through the middle handle and the
lower handle.
3. Tighten the handle knob(2) onto the bolt(1).
4. Repeat for left/right side.
7
2
1
2
1
EN