Store The Machine; Troubleshooting; Technical Data - GreenWorks Pro SNC404 Manuel D'opérateur

Masquer les pouces Voir aussi pour SNC404:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EN
8.4

STORE THE MACHINE

Clean the machine before storage.
Make sure the engine is not hot when you store the
machine.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, do these steps/
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person of an approved service
center.
Store the machine in a dry area.
Make sure that children cannot come near the
machine.
9

TROUBLESHOOTING

Problem
The handle is
not in position.
The machine
does not start.
The engine is
on, but the im-
peller does not
turn.
A thin layer of
snow stays be-
hind.
Possible cause
Solution
The bolts are not
Adjust the height
engaged correct-
of the handle
ly.
and make sure
that the knobs
and bolts are
aligned correctly.
The battery is
Charge the bat-
not charged.
tery by following
the procedures
in the battery
and charger
manual.
The switch is de-
Have the switch
fective.
replaced by an
authorized serv-
ice center.
Battery is too
Remove battery
cold.
from snow throw-
er. Place battery
on charger and
allow to charge
for 10 minutes or
until the chang-
ing light turns
green. Remove
from charger and
install in snow
thrower for use.
Battery may re-
Call toll free
quire service or
helpline, at
replacement.
1-855-345-3934
or replace bat-
tery.
The belt is dam-
Replace the belt.
aged.
The scraper is
Replace the
damaged.
scraper.
English
* If you cannot find the solution to these problems, call
1-855-345-3934 .
10

TECHNICAL DATA

Voltage
No load speed
Working width
Clearing depth
Impeller size
Discharge distance
Weight (without battery
pack)
Compatible battery model
Compatible charger model 2910402CT
10
THE RECOMMENDED AMBIENT
TEMPERATURE RANGE:
Item
Snow thrower storage
temperature range
Snow thrower operation
temperature range
Battery charging tempera-
ture range
Charger operation temper-
ature range
12
60 V
1,900 RPM
20 ''
10 ''
16 ''
19.7 ft
31.5 lbs (14.3kg)
2908402CT
Temperature
-4°F (-20°C) - 158°F
(70°C)
-4°F (-20°C) - 104°F
(40°C)
32°F (0°C) - 104°F (40°C)
39°F (4°C) - 113°F (45°C)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

060-0799-6

Table des Matières