Battery Replacement - Tripp-Lite BC350 Manuel D'utilisation

Features
7
USB Charging Port (INTERNET650U1 Only): The USB charging port delivers up to 5V
DC, 1A maximum charge current for use with cell phones, smartphones, MP3 players
and other devices compatible with USB chargers.
8
Tel/DSL/Network Protection Jacks: 8-wire RJ-style jacks protect a single Tel/DSL dialup
connection or 10Base-T Ethernet line connection.
Note: Connecting your equipment to these jacks is optional. Your UPS will work properly
without this connection.
9
Resettable Input Circuit Breaker: Protects your electrical circuit from overcurrent draw
from the combined load of equipment connected to the UPS and surge-only outlets. If
this breaker trips, remove some of the load, then reset by pressing it in.

Battery Replacement

Under normal conditions, the original battery in your UPS will last several years. Battery
replacement should only be performed by qualified personnel. Refer to "Battery Warnings" in
the Safety section for complete battery safety information.
The BC350, INTERNET350SER AND INTERNET350U require one DJW12-2.8 replacement
battery.
The BC450, BC500, INTERNET550SER, INTERNET550U, INTERNET600U AND
INTERNET650U1 require one SHR3.6-12 replacement battery.
For further information about replacement compatibility and ordering, visit Tripp Lite on the
Web at www.tripplite.com/products/battery-finder.
Battery replacement must be done using the same battery type and
quantity: 12V DC sealed lead-acid, 6 cell, and in compliance with UL 1989.
CAUTION: Risk of energy hazard. Before replacing batteries, remove
conductive jewelry such as chains, wrist watches and rings. High energy
passing through conductive materials may cause severe burns.
18-11-058-933864.indb 8
8
11/20/2018 8:28:42 AM