Powering On And Off - Zagg Slim Book Instructions

INSERTING/REMOVING YOUR iPad®
To insert your iPad® into the Slim Book open the Book's
case and remove it from the keyboard (to do this pull
the case up and away from the keyboard). Then, line
up your iPad with the holes in the case. Make sure the
camera hole is aligned properly as well as the opening
for the Lightning™ cable. When everything is aligned,
set the bottom half of your iPad in the cover and apply
light pressure to ensure it is properly settled. Snap the
top half of your iPad into the cover. Check all corners to
make sure they have seated properly.
When your iPad is secure in the case, you can connect it
with the keyboard by placing it in the magnetic trough.
Powerful magnets will secure it in place, but also allow
you to remove your iPad any time it benefits you.
To easily remove your iPad from the case, separate the
case from the keyboard, and then gently roll the rubber
overmold away from the edges while pressing the tablet
from behind. Grasp your tablet's exposed side and lift/
pull away from the Slim Book.

POWERING ON AND OFF

To turn your Slim Book on, press the Power button. A green
LED on the battery key will illuminate briefly while the
keyboard powers up. To turn your Slim Book off,
press and hold the Power button for
three seconds. A red LED will flash,
indicating your Slim Book has
turned off.
1