Appendix; Technical Data; Troubleshooting - hager WXH20 Serie Mode D'emploi

z

6 Appendix

6.1 Technical data

Sensor unit
Battery type
Recommended battery type
Power
Battery service life
Sound pressure at a distance of 1 m 70 ... 75 dB
(A)
Radio frequency
Range
depending on building structure
Dimensions (W x H x D)
Degree of contamination
Power control unit
Rated voltage, 3phase
Rated current, 3phase
Conductor cross-section, 3phase

6.2 Troubleshooting

Power supply to the cooker is switched
off.
Cause 1: Battery level of the sensor unit is too low.
Battery display (7) flashes.
Replace batteries.
Cause 2: Mounting position of the sensor unit
is wrong and the status LED (5) flashes yellow
(●●●).
Check mounting position of the sensor unit
and adjust if necessary (Figure 7).
Cause 3: Radio connection is interrupted and
status LED (5) flashes blue (●).
36
AA/LR6 Alkaline
Duracell Ultra
(MX1500)
3 ... 5 years
2.4 GHz
10 ... 100 m,
125 x 17 x 45 mm
2
400 V
3 x 16 A
5 x 2.5 mm²
Rated voltage, 1phase
Rated current, 1phase
Conductor cross-section, 1phase
Energy consumption
Degree of contamination
Rated surge voltage
Operating temperature
Ball pressure test
Creep resistance (PTI)
Number of switching operations
Degree of protection
Dimensions (L x W x H)
Standard
Potential-free contacts
Rated voltage
Rated current
Establish radio connection manually in setting
mode 2 (see Manual commissioning).
Cause 4: Power control unit is overheated and
status LED (5) flashes blue (●●●).
Let the device cool down for a while. If it
occurs again, contact an electrician.
Cause 5: Problem with the sensor unit and
status LED (5) flashes yellow (●●).
Check batteries or have sensor unit
checked.
Cause 6: Problem with the sensors and status
LED (5) flashes yellow (●).
Clean sensor unit and sensors carefully.
1 x 25 A
3 x 6 mm²
+5 ... +35°C
100 °C
175 ... 400
approx. 6000
239 x 113 x 42 mm
IEC/EN 60730-1: Type 1.B
DIN EN 50615
DC 3 ... 24 V
max. 10 mA
230 V
4 W
2
4 kV
IP20