hager WXH20 Serie Mode D'emploi page 34

z
Setting mode 1: Setting alarm limit
The alarm limit is preset to 6 in default state.
This means that the sensor unit is mounted at
a height of 50 ... 60 cm (wall mounting) or 55
... 65 cm (mounting under the extractor hood).
If the mounting heights vary from the standard,
the alarm limit (Table 5) must be adjusted.
The recommended alarm limit (4 - 7) depends
on the position of the cooker, installation height,
installation mode and reaction behaviour of the
sensor unit. The values are between 1 and 12
(1 = fastest reaction, 12 = slowest reaction).
The setting mode 1 is activated. The status LED
lights up white.
Select suitable, recommended alarm limits
„
from Table 6.
Press operation button (2).
„
The next higher level is set and the setting
mode 1 is left.
OR:
Press operation button (1).
„
34
oder
Figure 10: Calibrating cooker type manually
The next lower alarm limit is set and the
setting mode 1 is left.
The new alarm limit is displayed according
to the data in Table 6 and signalled via the
colour of the Status LED and the number of
tones.
To set another alarm limit the setting mode 1
has to be called up.
Setting mode 2: Establishing radio
connection
Setting mode 2 is called up. The status LED (5)
flashes twice purple-blue.
Switch off circuit breaker of the cooker/hob
„
for 10 s.
Switch on fuse again.
„
The power control unit searches for the
sensor unit automatically.
If connection is successful, the sensor unit
acknowledges with three acoustic signals
(●●●). The cookguard ends the automatic
setting mode.