Octane Fitness XR6000 Manuel D'utilisation page 9

• Press until the desired Country is shown.
• Press to highlight "Air/Cable" , then press
• Press to highlight "Start Scan", then press
the PVS will not recognize all the channels that are available.
The TV will now scan all of the channels available in the area. This may take a few minutes, especially for digital
channels. A bar display will indicate progress of the Digital TV (DTV) channels and then repeat the search for Analog
TV (ATV) channels. When finished, the TV will tune to the lowest receivable channel. It is now ready to use.
Note: If you wish to stop the channel scanning procedure, press
scan process will result in a reduced number of channels available for viewing.
If system is not functioning properly, turn the PVS off for one minute, and then turn it back on to re-initialize the
system. In most cases, this will reset any malfunctions with the PVS. If you continue to have problems, please
check the troubleshooting guide located at the end of this manual. If the issue is not resolved or not covered in the
troubleshooting guide, please call your dealer or contact Octane Fitness Customer Service for additional assistance.
Channel Scan Menu
Tuner Version
Country
Air/Cable
Start Scan
Display Channels Menu
Save Channels To USB
Load Channels From USB
Exit
Move Select/Modify
to select the signal source: Air or Cable.
to start the channel scan. If you do not complete this step,
1.26
Argentina
Air
Exit
. However, please be aware that stopping the
ENG-4