Other Important Safety Precautions; Power Supply Specifications - Octane Fitness XR6000 Manuel D'utilisation

OTHER IMPORTANT SAFETY PRECAUTIONS

• Power Lines
An outside antenna system should not be located in the vicinity of overhead power lines or other electric
light or power circuits, or where it can fall into power lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from touching power lines or circuits; contact with them
might be fatal.
• Handling the LCD Panel
The LED and LCD panels are made of glass. Do NOT drop, hit, jolt, or press hard against the panel. If the
screen breaks, beware of sharp edges or broken glass.
• Replacement parts
When replacement parts are required, make sure that the service technician uses replacement parts having
the same characteristics as the original part as specified by the manufacturer. Unauthorized substitutions
may result in fire, electric shock, personal injury, or other hazards. Ask the service technician to perform
routine safety checks to determine the PVS is in correct operating condition after any service or repair to this
device.
• Condensation
Moisture will form on the PVS if it is brought from cool surroundings into a warm room or if the temperature
of the room rises suddenly. When this happens, the PVS's performance may be impaired. To prevent this,
allow the PVS to sit in new surroundings for one hour before switching on, or make sure that the room
temperature rises gradually. Condensation may also form during the summer if the PVS is exposed to the
breeze from an air conditioner. In such cases, change the location of the PVS.
• Mobile Communication Devices
Phones and other mobile communication devices can cause interference with the picture and/or sound
quality. If you experience undesirable performance by this appliance in close proximity to one of these
devices, please relocate the device a great enough distance away from the PVS to eliminate the undesired
condition.
External Power Supply:
Input Rating: 100 - 240V AC, 50/60Hz
Output Rating: 12V DC, 12.5A Maximum
Elliptical Input Power Requirements:
12V DC
8.5A Maximum
Power Supply Notice
Personal Viewing Screen (PVS) models 109124-001, 109125-001, 109126-001, 110455-001, 110800-001 and 110900-001 may only be used
with FSP Group power supply model number FSP150-AHAN1.
ENG-ii

POWER SUPPLY SPECIFICATIONS