Control Board - England's Stove Works 25-PDV Guide D'installation Et D'utilisation

The Control Board (Part #PU-CB04) is a digital read-out board. This board offers a wide variety of
settings to operate the unit. This part can be removed from the unit by loosening the two outside
screws and pulling the board back to the inside of the stove. The rear access panel should be
removed prior to removing the control board. A 6-amp "quick-blow" fuse is used on this Control
Board.
NOTE: The bottom three control buttons are preset at the factory and should not require any
changes. See "Operating Instructions" and "Daily Operation" section of the manual for
instructions on other Control Board settings.
Low Burn:
Medium Low:
Medium High: Heat Range setting: 5 – 8
High Burn:
* NOTE: Blower Speed will automatically be adjusted to the desired Heat Range that you select.
CAUTION:
NOTE: The bottom
3 buttons are pre-set at
the factory and do not
need adjustment.
Call Service at
(800) 245-6489 if you
have questions
problems.
Should you see any evidence of smoke in the hopper (smoke back),
immediately close and latch the hopper lid and door to the unit. Open the
nearest windows and door to the outside, then press the OFF button and let
the unit cool for at least 3 hours. Do not open the door or hopper lid. This is a
maintenance problem that needs to be addressed.
Call Technical Support at (800) 245-6489
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING
CLEANING THE UNIT AS SPECIFIED, AND REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR
DUE TO UNSAFE INSTALLATION OR USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH QUESTIONS.
Recommended Heat Ranges:
Heat Range setting: 1
Heat Range setting: 2 – 3
Heat Range setting: 9
or
Caution

Control Board

Room Air Blower setting: 1
Room Air Blower setting: *
Room Air Blower setting: *
Room Air Blower setting: 9
21
Illustration 3
Control Board
Diagram