Installation Space - GE Appliances PCR06BATSS Manuel D'utilisation Et Instructions D'installation

INSTALLATION SPACE

The beverage center and wine chiller can be a
free-standing model or it can be built in using the
cut-out dimensions below.
9" Max.
34-1/2"-35"
Product dimensions:
Height: 34-1/2" (876 mm)
Width: 23-3/4" (603 mm)
Depth: 25-1/2" (647 mm)
Cut-out dimensions:
Height: 34-1/2–35" (876–889 mm)
Width: 24" (610 mm) minimum
Depth: 24" (610 mm) minimum
The cutout depth should be 24"
The cutout dimensions shown allow for a full
door swing and access to the pull-out racks when
installed as a built-in in standard 24" deep cabinets.
• The door should protrude 2-1/4" beyond the
surrounding cabinets. For easy reference, the
back edge of the pocket handle should protrude
a minimum of 5/8" beyond the front edge of the
countertop.
• If installing between frameless cabinets, a 1/2"
wide filler strip or side panel may be needed on
hinge side. The filler strip will act as a spacer
between the case and adjacent cabinet door
swing. The width of the opening must include the
filler panels. NOTE: The door should protrude
2-1/4" beyond the surrounding cabinets.
• The beverage center and wine chiller can be
installed freestanding.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical
must be located on rear wall as shown.
NOTE: GFI (ground fault interrupter) is not
recommended.
10
Installation Instructions
Locate
Outlet
10-1/2"
24"
1-1/2"
25-1/2"
24" Min.
23-3/4"
SIDE-BY-SIDE INSTALLATIONS
Increase storage capacity by installing two
beverage centers or wine chillers together. Or, for
a complete refreshment center, install any two of
these units together.
• A side-by-side installation requires at least a
47-1/2" wide opening. No trim kits required.
• Products must operate from separate, properly
grounded receptacles.
34-1/2"
34-1/2"-35"
Locate
Outlet
10-1/2" 10-1/2"
24"
14"
9" 9"
15"
1-1/2"
47-1/2" Min.
49-60466-3