An Overview Of The Paslode Cordless Framing Nailer - Paslode CF325XP Manuel D'utilisation

An Overview of the Paslode Cordless Framing Nailer

Description
The Paslode Cordless Framing Nailer is a self-contained,
fully portable nailer that uses liquid hydrocarbon fuel to
power a unique linear drive internal combustion motor.
As with any internal combustion motor, the Paslode Cordless
Nailer will require periodic maintenance to keep it operating
at it's peak performance. The cleaning procedure booklet
will instruct you on the proper cleaning of your tool. If
additional services are required, contact your local Paslode
service provider.
NOTE: Altitude Restriction
Paslode Cordless tools are powered by an internal
combustion engine and are effected by altitude. The
tool may lose power or not cycle consistantly at
elevations of 6000 feet or greater.
Motor Housing
MOTOR ASSEMBLY
Adjustable
Work-Contacting
Element
Toe Nailing Teeth
4
Specifications
Dimensions: Weight (with battery) 7.2 pounds
Height 14-1/2 inches
Length 12 inches
Cycle Rate: Intermittent Operation – 2 to 3 nails
NOTE: Exceeding these rates could cause tool to overheat,
resulting in loss of performance or damage to tool
components.
By using the Paslode Cordless Framing Nailer at its
recommended cycle rate, you will be able to drive several
thousand nails in a typical workday.
Fasteners: 30° paper tape collation
Minimum 2 inch x .113 diameter shank
Maximum 3-1/4 inch x .131 diameter shank
Magazine Capacity: 1 nail strip + 5 fasteners.
Battery : 7.4 volts DC - Provides enough energy to
drive approximately 9000 fasteners on a full
charge.
Fuel Cell: Orange quicklode™ fuel cartridge (1.32 oz)
Liquid hydrocarbon - Provides enough fuel
to drive approximately 1200 fasteners.
Cover and Filter
Fuel Cartridge Compartment
Battery
Indicator Light (LED)
Follower
per second
Utility Hook
HANDLE ASSEMBLY
Battery
Compartment
(Opposite Side)
Channel magazine