Control Panel - LEITZ TruSens Z-3000 Mode D'emploi

CONTROL PANEL

Power Button
Fan Speed Settings
Select fan speed or AUTO mode. In AUTO mode,
purifier automatically adjusts fan speed based on air
quality readings from SensorPod
(AUTO mode only available when purifier is paired with
SensorPod and receiving signal)
Dimmer Mode
Display illumination turns off – for use while sleeping –
without sacrificing the effectiveness of the purifier.
Simply press the button again to bring back all
display features.
10
.
™
Timer Mode
Purifier will automatically turn off after 2, 4, 8, or 12
hours. To cancel this countdown, simply press button
until no timer setting is displayed.
UV Mode
UV bulb within the purifier's filter chamber is on when
the symbol is white. The
when it is time to replace the UV bulb.
(See page 15 for replacement instructions)
Filter and UV Indicator Reset
HEPA, Carbon and UV indicators glow red when it is
time for each to be replaced.
When 1 indicator is on, simply hold Reset button for 3
seconds to reset that indicator. When 2+ indicators are
on, tap the Reset button to select the correct indicator
(selected indicator will blink) before holding 3 seconds
to reset that indicator.
(See pages 13-15 for replacement instructions. Follow above Reset
button instructions after replacing filter.)
symbol will glow red