Restoring The Original Configuration - SOMFY Oximo 40 io Notice

EN
2.4.2. Replacing a lost or broken Somfy control point

Only switch off the power to the application to be reset.
This reset deletes all the local control points, however the sensors, end limit settings and favour-
ite position are retained.
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product
5)
moves for a few seconds. (If the application is in the upper
or lower limit position, it will make a brief up and down
movement).
Press the PROG button on the new control point until the
6)
motorised product moves up and down: the new control
point is programmed and all the other control points are
deleted.

2.4.3. Restoring the original configuration


Only switch off the power to the application to be reset.
This reset deletes all control points, all the sensors and all the end limit settings, and resets the
motor's favourite position (my).
Position the motorised product at the mid-height position.
1)
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15 seconds.
3)
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised product
5)
moves for a few seconds. (If the application is at the
upper or lower end limit, it will make a brief up and down
movement).
Press the PROG button on the Somfy local control point for
6)
≈ 7 seconds, until the motorised product moves up and
down twice:
The motorisation is reset to the original configuration.
→
Repeat the
-
Commissioning) section.
8
commissioning procedure
Images not contractually binding
1
3
ON
10 sec.
5
ON
1
3
ON
10 sec.
5
ON
(see
Copyright © 2016 Somfy SAS. All rights reserved
2
OFF
2 sec.
4
OFF
2 sec.
6
PROG.
2
OFF
2 sec.
4
OFF
2 sec.
6
my
PROG.
X2