Table des Matières
Publicité
I1200
installation
12
|
Regular/Oversize Faceplate Installation:
1) Thread the black 1/4" x 3/4" long hex bolts into the faceplate mount-
ing bracket as shown in Diagram 1, leaving them approximately 1/4"
out.
2) Fasten the faceplate mounting bracket to the side of the insert using 2
bolts for the top and bottom, see Diagram 1. Repeat for other side.
NOTE: The bolt and washer come attached to the side of the insert
and need to be removed and reused for fastening.
3) Assemble the faceplate sides and top using the 1/4" x 1/2" long hex
bolts, lock washers and nuts provided. See Diagram 2.
Diagram 2
If the insert is going to sit on the hearth
proceed to "Faceplate Trim Installation"
(step 8) otherwise continue on to "Bottom
Faceplate Installation" (step 4).
12 | Regency I1200
918-676c
Diagram 1
Rear View
Optional Regular/Oversize Bottom Faceplate
Installation:
4)
osition the assembled faceplate side and top to the insert. nsure
to align the draft rod into the opening of the faceplate as well as the
side faceplate slots with the bolts in the mounting brackets as shown
in Diagram 3.
5)
easure the height between the hearth and the bottom of the side
faceplate.
6)
ut the bottom faceplate to the measured height using a metal cutting
blade.
7) Remove the faceplate assembly from the insert and attach the cut
bottom faceplate to the faceplate sides using the 1/4" x 1/2" long hex
bolts, lock washers and nuts provided as shown in Diagram 4.
Diagram 4
2
Diagram 3
Rear View
01/28/08
Publicité
Table des Matières
