Troubleshooting - Bosch TASSIMO TAS40 Serie Notice D'utilisation

24

Troubleshooting

Problem
Appliance not working;
no symbols light up.
Machine brews but no
drink dispensed.
O
Automatic mode
not working, appliance
remains in stand-by
mode.
O
Automatic mode
skipped, appliance
goes straight to
N
manual mode.
Robert Bosch Hausgeräte GmbH
The following table provides solutions for problems and glitches
that may arise as you use your TASSIMO machine. If you do not
find a solution for your specific problem, or the problem persists
after troubleshooting please contact our customer service
department.
Possible cause
There is no power supply.
The water tank was removed
during the brewing process or
there is air in the system.
The float in the water tank is
stuck.
No T DISC inserted.
The barcode could not be
detected.
The barcode could not be
detected.
Solution
Check that the appliance is
plugged into the power supply.
Replace the water tank in the
appropriate position in your
TASSIMO machine. Start a
cleaning process with the
Service T DISC.
Clean the water tank and
ensure the float can move.
Check if T DISC has been
inserted.
Clean the bar code reading
window and try again or
smooth the barcode on the
T DISC out with your thoumb.
Use another T DISC.
If problems persist contact the
TASSIMO careline.
08 00 032 88 33
You can still prepare the drink
by holding down the start /stop
button.
en