Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DRAWER INSTALLATION
A
PARTS SUPPLIED
B
4 Screws
FIGURE 5
1. Place the drawer adjacent to the wall or cabinet opening.
Plug the power supply cord into the electrical outlet.
2. Carefully guide the drawer into the prepared opening. Avoid
pinching the cord between the oven and the wall.
3. Slide the drawer all the way until the mounting flange is
flush with the face of the cabinet. See figure 5A.
4. Open the drawer. Using the 4 holes on the drawer as a tem-
plate, pre drill the cabinet using a 1/16" bit. See figure 5A.
5. Secure the drawer with the 4 screws supplied. See figure
5B.
E
Mounting Screws
6
MODEL AND SERIAL NUMBER
LOCATION
The nameplate includes model number and serial number.
Open the Drawer Microwave fully. The label is slightly beyond
the back wall of the microwave cavity facing up from the flat
surface.
CARE, CLEANING AND
MAINTENANCE
Refer to the Use and Care Manual for cleaning instructions.
BEFORE YOU CALL FOR SERVICE
Read the BEFORE YOU CALL and operating instruction sec-
tions in your Use and Care Manual. It may save you time and
expense. The list includes common occurrences that are not
the result of defective workmanship or materials in this range.
Refer to the warranty in your Use and Care Manual for toll-
free service number and address. Please call or write if you
have inquiries about your microwave product and/or need to
order parts.
Visit www.encompass.com to purchase spare parts.
Publicité
Table des Matières
