Favero Electronics ARCHERY TIMER Mode D'emploi Et D'installation page 8

ENGLISH
4.2. Shooting sequence operating modes
For each "shooting sequence", besides time durations, it is also possible to set the following operating
modes (parameter F setup, chap. 5.2).
Single turn (F = U1). There is a single shooting turn, preceded
1
by the preparation interval.
Double turn (F = U2). There are 2 consecutive turns, each
2 signaled by displaying "Ab" or "Cd" during the preparation
interval.
Triple turn (F = U3). There are 3 consecutive turns, each
3 signaled by displaying "Ab" or "Cd" or "EF" during the
preparation interval.
Make up arrows (F = r). There is a single shooting turn, for
4 which the preparation interval is signaled by 4 acoustic
signals.
Alternate shooting with single turn (F = A1). The single
shooting turn of the 2 archers is carried out in sequence and
5
is signaled by displaying "A" and "b". There is no warning
interval.
Alternate shooting with double turn (F = A2). The two
shooting turns of the 2 archers are carried out in sequence
6
and are signaled by displaying "A" and "b". There is no
warning interval.
Alternate shooting with triple turn (F = A3). The three
shooting turns of the 2 archers are carried out in sequence
7
and are signaled by displaying "A" and "b". There is no
warning interval.
At the end of a "shooting sequence", the following sequence is automatically loaded with the
correct shooting turn identifier (A, b, Ab, Cd, ...).
During the preparation interval, you can use [F2] to change the shooting turn identifier
("A"  "b", "Ab"  "Cd"  "EF").
4.3. Selecting, starting and stopping a shooting sequence
To select a "shooting sequence":
• press the [TIMER] key several times until the desired "shooting sequence" is displayed
("t1", "t2", ..., "t9"), and
• within 3 seconds press [STOP]
1. Press [START] instead of [STOP] to start timing immediately.
8
/ 44
.
1
00155-M01-ML - Archery Timer User Manual Rev01 - 151029 -
FAV E RO E L EC T RO NIC S