Publicité
This product is designed for removing or
polishing material using abrasives or
polishing attachments. No other use permitted. For
professional use only. Before servicing the power
tool, the supply of compressed air must be
disconnected or shut off.
The tool is fully stopped only several seconds
after the on/off system has been released.
The tool must not be operated at free speed.
The tool is designed for a working pressure of
6.3 bar (90 psig). The compressed air must
b e c l e a n . T h e i n s t a l l a t i o n o f a f i l t e r i s
recommended. For maximum efficiency and
performance, comply with the specification of the
air hose (antistatic hose). (Refer to figure no.1 for
compressed air connection)
ømini mm = 6 (1/4")
The use of spare parts other than those
originally supplied by the manufacturer may
r esult in a d rop in pe rfor mance or in
increased maintenance and level of vibration
and in the full cancellation of the manufacturer's
liability.
To obtain maximum efficiency from the
pneumatic tool, preserve its features and
avoid repeated repairs, a routine inspection and
repair programme are recommended at least every
500 hours, the intervals between the various
inspections depending on the amount of exertion
on the power tool.
When disposing of components, lubricants,
e t c . , e n s u r e t h a t t h e r e l e v a n t s a f e t y
procedures are carried out.
Check the free speed of the tool at regular
inter vals and after each operation or
maintenance task. Remove the abrasive to check
1
KLA14
INSTRUCTIONS
7 m max.
the speed. The maximum allowed speed shown on
the tool must not be exceeded and the vibration
level must not be excessive.
This tool is fitted with blades which can
operate without lubricated air. However, a
small amount of oil allows the tool to provide
full power and lengthens its life.The use of dry air
with no trace of oil may reduce the life of blades.
For dust extraction, please contact your local
sales.
Lubricating the bevel gear. Amount of
g r e a s e : 1 g r . R e c o m m e n d e d g r e a s e :
615 990149 0 (Qty: 24gr) or 615 990148 0
(Qty: 1Kg). The use of any other lubricant, in any
other amount, will shorten the life and impair the
operation of angle pinions.
© Copyright 2008, Desoutter St Herblain France
All rights reserved. Any unauthorized use or
copying of the contents or part thereof is prohibited.
This applies in particular to trademarks, model
denominations, part numbers and drawings. Use
only authorized parts. Any damage or malfunction
caused by the use of unauthorised parts is not
covered by Warranty or Product Liability.
Part no
6159943470
Issue no
02
Series no
C
Date
04/2010
Page
7 / 34
Publicité
