JOBO ProTime 100 Mode D'emploi page 16

Start
Start the program by pressing START. The dis-
play will then count down from the programmed
time. In addition, the unit will give audio signals
as follows:
15 secs before end of step:
4 short beeps
10 secs before end of step:
3 short beeps
05 secs before end of step:
2 short beeps,
then one short beep at 4, 3, 2, and
1 seconds before the end of the
step.
When time is elapsed:
1 long beep
Every two seconds:
1 long beep up to 59 seconds after
Every minute:
1 long beep up to 1 hour after
If time is exceeded, a - sign is indicated.
Start of next process step
Press START to start the next process step. A
"CH' symbol is displayed for a chemistry step,
and a 'W' for a wash or rinse step and the accor-
ding time counts down.
Display of program
To check the current program No. whilst it is
running, press both the "up" and "down" but-
tons at the same time.
13