Power Supply; Use With Pre-Programmed Process Steps - JOBO ProTime 100 Mode D'emploi

3.

Power Supply

Open the battery cover on the rear of the instru-
ment and insert a PP9 9V battery. The Jobo
ProTime 100 is now ready for use. The ProTime
is fitted with a memory which stores program
settings even if the battery is exhausted and
whilst it is being replaced.
4. Use with Pre-Programmed Process
Steps
All the pre-programmed process steps are
described in the Appendix in this manual.
Review these and decide on which process
number you wish to time. 3 bath E-6, for
instance, is program No. 3.
Selection of program
Switch on the Jobo ProTime 100. First, the cur-
rent program selected will be displayed for two
seconds. Then the first step of that program is
displayed with the 'P' symbol, indicating a pre-
heat or pre-wash. If this is the program you wish
to use, skip the next operation.
Select the program you wish to use by keeping
the START button pressed whilst repeatedly
pressing either the UP or DOWN buttons until
the desired program number is displayed. The
display will then show the first step 'P' of the
program selected.
i.e.
12
or