Leuze electronic OGS 600- /CN-M12 Serie Manuel D'utilisation page 17

Certified electricians
Electrical work must be carried out by a certified electrician.
Due to their technical training, knowledge and experience as well as their familiarity
with relevant standards and regulations, certified electricians are able to perform
work on electrical systems and independently detect possible dangers.
In Germany, certified electricians must fulfill the requirements of accident-preven-
tion regulations DGUV V3 (e.g. electrician foreman). In other countries, there are
respective regulations that must be observed.
Exemption of liability
Leuze electronic GmbH + Co. KG is not liable in the following cases:
- The device is not being used properly.
- Reasonably foreseeable misuse is not taken into account.
- Mounting and electrical connection are not properly performed.
- Changes (e.g., constructional) are made to the device.
Overview
1
A Integrated illumination – transmitter (small lenses)
B Receiver modules – receiver (large lenses)
C Groove with 2 sliding blocks for fastening the mounting bracket
D 2 x M12 connector, 5-pin
E 1 x M12 connector, 8-pin
Part number code
/YY
OGS 600- XXX -M12 .8
N/A 2x 5-pin
.8 1x 8-pin
M12 connection technology
/CN CANopen and RS232 interface
/D3 RS485 interface
/D2 RS422 interface
280 Long version
140 Short version
Optical guidance sensor,
OGS 600 series
(Optical Guidance Sensor)
EN
17