Warning Label Identification - Ingersoll Rand 307A Manuel D'instructions

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Do not use this tool if actual free speed exceeds the
•
nameplate rpm.
Before mounting a wheel, after any tool repair or
•
whenever a Grinder is issued for use, check free
speed of Grinder with a tachometer to make
certain its actual speed at 90 psig (6.2 bar/620
kPa) does not exceed rpm stamped or printed on
the nameplate. Grinders in use on the job must be
similarly checked at least once each shift.
Do not use any grinding wheel, bur or other
•
accessory having a maximum operating speed less
than the free speed of the Grinder in which it is
being used. Always conform to maximum rpm on
grinding wheel blotters.
Inspect all grinding wheels for chips or cracks
•
prior to mounting. Do not use a wheel that is
chipped or cracked or otherwise damaged. Do not
use a wheel that has been soaked in water or any
other liquid.
After mounting a new wheel, hold the Grinder
•
under a steel workbench or inside a casting and
run it for at least 60 seconds. Make certain no one
is within the operating plane of the grinding wheel.
If a wheel is defective, improperly mounted or the
wrong size and speed, this is the time it will usually
fail.

WARNING LABEL IDENTIFICATION

Always wear hearing
protection when operating
this tool.
Do not carry the tool by the
hose.
90 psig
Operate at 90 psig (6.2 bar/
(6.2bar/620kPa)
620 kPa) Maximum air pres-
sure.
GRINDER SPECIFIC WARNINGS
WARNING
WARNING
WARNING
When starting with a cold wheel, apply it to the
•
work slowly until the wheel gradually warms up.
Make smooth contact with the work and avoid any
bumping action or excessive pressure.
Model 307A Die Grinder has a free speed of
•
27,000 rpm when operated at 90 psig (6.2 bar/
620 kPa) air pressure. Operation at higher air
pressure will result in excessive speed.
Always match collet size with accessory shank size.
•
Always insert tool shank no less than 10 mm in the
•
collet. Tighten Collet Nut securely to prevent
accessory from working out during operation of
the Grinder. Check tightness of Collet Nut before
operating the Grinder. Pay particular attention to
the fact that allowed speed of a mounted point is
lowered when the length of the shaft is increased
between end of collet and mounted point
(overhang).
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________