Safety Instructions / Warnings; Proper Use - Heitronic 37285 Mode D'emploi

GB Installation and Operating Instructions
Solar LED light with motion sensor
Art. No. 37285.37295
These operating instructions refer exclusively to the above products.
They contain important information for the start-up and handling of the product.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The product fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions / Warnings


In the event of damage which is caused by not following these operating instructions,
the warranty is rendered void.

We do not accept liability for any consequential damage!

Commissioning is strictly prohibited if there are any damages to the product!

The product in its entirety must not be altered or modified.
Alterations to the product invalidate the guarantee.

The type plate must not be removed.

Avoid staring directly into the LED when switched on

Remove the batteries for longer periods out of use. Batteries may leak (risk of chemical burns)

3. Proper Use


The solar light is designed for use in outdoor areas.

The light switches on automatically at dusk and off again at dawn.

High performance light diodes (LED) are used as the source of light. These LEDs guarantee high light
intensity with low power consumption.
However, please note that little sunlight on the solar module and during the winter months can lead to
impairment to the period of light/illumination.
Note: the period of light/light intensity heavily depends on the duration and intensity of the sun's rays during
the day. The battery is not charged sufficiently in case of longer periods without sunlight so that constant
availability for operation cannot be guaranteed. However, this does not mean that the solar light is defective.
Wait until the sun shines and the light will work again.
4. Before Installation/Commissioning

The product must only be used outside its packaging.

Take the product carefully out of the packaging.
1 of 4 | Dated 28.06.2017