Chauvet COLORdash Batten-Quad 12 Manuel De Référence page 3

EN
Replacing the
Fuse
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
Control Panel
Description
1.
Disconnect this product from power.
2.
Using a flat-head screwdriver, unscrew the fuse holder cap from the
housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The COLORdash™ Batten-Quad 12 will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The COLORdash™ Batten-Quad 12 uses a regular DMX data connection for
its DMX personalities: 4 Ch, 6 Ch, 10 Ch, 48 Ch, and 52 Ch. See the User
Manual to connect and configure for DMX operation.
The COLORdash™ Batten-Quad 12 uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
Safety
Cable
Button
<MENU> Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases
<DOWN>
the numeric value when in a function
COLORdash™ Batten-Quad 12 QRG
Overhead Mounting
Floor Mounting
Function
3
Clamp