AGA marvel ML15WSG2 Serie Instructions D'installation, D'utilisation Et D'entretien page 7

Floor Mount Installation
Step by step instructions for locating the
position of the bracket:
1) Decide where you want to place the wine cellar.
Slide it into place, being careful not to damage the floor,
leaving 1" (2.5 cm) of clearance from the rear wall to allow
room for the anti-tip bracket.
2) Raise the rear leveling legs approximately
mm) to allow engagement with the anti-tip bracket. Level
the unit by adjusting all the leveling legs as required.
Turning the leveling leg counterclockwise will raise the
unit and clockwise will lower the unit.
3) Make sure the wine cellar is in the desired
location, then mark on the floor the rear and side corner of
the cabinet where the anti-tip bracket will be installed. If
the installation does not allow marking the rear corner of
The anti-tip bracket is to be located on the floor in the left or right
rear corner of the wine cellar as shown in Figure 7.
INSTALLING THE ANTI TIP DEVICE FOR FREESTANDING
NOTE
When the floor mounted anti-tip bracket is used the
minimum adjusted height of the cabinet is increased by
⁄
3 " (9 mm).
8
the cabinet, then make temporary lines on the floor
marking the front corner of the cabinet, excluding the
door. Slide the wine cellar out of the way. From the
temporary line extend the sidewall line back 21
cm) as shown in Figure 8.
4) Align the anti-tip bracket to the marks on the floor
so the side of the bracket lines up with the side of the
cabinet mark, and the "V" notches on the anti-tip bracket
⁄
" (6
1
4
line up with the end of the 21
cabinet line).
5) Fasten the anti-tip bracket to the floor using the
supplied screw. (See Figure 8).
6) Slide the cabinet back into position, making sure
the rear cabinet leveling leg slides under the anti-tip
bracket engaging the slot.
INSTALLATIONS
7
⁄
" (54.6
1
2
⁄
1 " (54.6 cm) line (Rear of
2