AGA marvel ML15WSG2 Serie Instructions D'installation, D'utilisation Et D'entretien page 22

OVERLAY DOOR
INSTALLATI
Step 4: Assemble the panel to the door
The preferred method of attaching the panel to the door is
to clamp the panel to the door so it cannot move while
drilling the screw pilot holes. Use bar clamps or "C"
clamps with pads on the clamping surfaces that will not
mar the panel or the door. The custom overlay panel
should be flush with the top of the door and centered
along the width of the door. See Figure 15a. Drill holes
through the gasket extrusion using the 10 holes as pilot
holes. Use the drill size from the chart in Table "B", being
careful not to drill through the front surface of the panel. If
⁄
the overlay panel is thinner than " (16 mm) thick shorter
5
8
screws will have to be obtained. Fasten the panel to the
door with the 10 screws provided in the literature pack.
(See Figure 24). Remove the clamps and replace the
gasket in the gasket extrusion channels of the door. Some
force may be required to seat the gasket into the
channels. Be sure the gasket corners are seated properly.
22