Electronic Control; Your Appliance; Turning Your Appliance "On" Or "Off; Adjusting The Temperature - AGA marvel ML15WSG2 Serie Instructions D'installation, D'utilisation Et D'entretien

Temp
Plug the appliance power cord into a 115 volt wall outlet.
Your appliance is shipped from the factory in the "On"
position and will begin start-up of cooling as soon as
power is supplied. If the appliance does not start, confirm
that the wall outlet has power, and that the control is in the
"On" position, (See "Turning your appliance On and Off"
below).
The control display is covered with a clear plastic film. This
film may be removed by carefully lifting the film at a corner.
On initial power up, the control display will indicate a
"Power Failure" alarm. This is a normal condition as the
appliance was powered-up at the factory for quality
inspection and then removed from power. A momentary
press of the "On/Off" keypad will reset this alarm condition.
(See Alarms section on page 12).
Sleep mode (Single and Dual Zone):
If no keypads are pressed for 60 seconds, the display will
enter sleep mode to conserve power. The control panel will
go dark with the exception of the system status "OK"
indicator which will remain enabled. Alarm conditions will
wake the display, (see alarms on page 12).
To make the following changes to the control settings
(turning the appliance ON/OFF, adjusting the
temperature, changing the interior lights, and
activating vacation mode), the control must be awake.
To wake the display press any keypad. A confirm tone will
sound, and the current storage compartment temperature
will be displayed.
keypad for 4-seconds.
USING YOUR ELECTRONIC
CONTROL
Upper/Lower
Temp zones Lights keypad
The sleep mode can be disabled if you prefer to have the
display on continuously. Press and hold the "Lock" keypad
until the display goes past "Loc" and reads "nSL". To
enable the sleep mode, repeat the instruction, again going
past "Loc" until the display reads "SLP".
Turning your appliance ON and OFF (Single
and Dual Zone):
control.
To turn the appliance "On", press and hold the "On/Off"
If the appliance is "On", (and out of sleep mode) the
temperature will be shown in the display area of the
control. To turn the appliance "Off", press and hold the
"On/Off" keypad for 4-seconds. "OFF" will now be
displayed on the

Adjusting the temperature:

NOTE
When initially loading your product with warm contents, it
may take up to 48-hours for the storage compartment
temperature to stabilize.
When making temperature set-point changes, it may take
up to 24-hours for the stored contents to stabilize at your
new set-point temperature.
Factors that affect the storage compartment stabilized
temperature:
•
Changes to temperature setting.
•
Room temperature changes.
•
Temperature of stored contents.
12