ThermoTec AeroFlow Heater Manuel page 9

Instruction knob thermostat (ITRP)
25°C
30°C
Operational use display examples:
Equipment is "off"
Instruction wireless receiver
Associating the receiver
With a transmitter thermostat Press the receiver button until the LED flashes (~3 seconds). Put the transmitter into
association mode (see transmitter guide). Check that the receiver LED is no longer flashing. The receiver is associated
with the transmitter.
With a control system transmitter
Press the receiver button until the LED flashes (~3 seconds). 2 possible choices. Slow flashing: simple lighting mode
Rapid flashing: pulse mode. Press the receiver button briefly to pass from One rate of flashing to the other.
On the transmitter, send the association radio information (see transmitter guide). Check that the receiver's LED is no
longer
Flashing.
Application example:
with a door/window magnetic contact. When associated with the receiver,
the magnetic contact can: - in control system mode, report the magnetic contact's status (open/closed), - in heating
mode, for instance when there is
an open window, switch the heating to frost protection.
Removing all the receiver associations
Press and hold the button. The LED flashes after 3 seconds.
Hold down the button. The relay reverses after 10 seconds and the LED no longer flashes (reverse current relay mode
active). Hold down the button.
The LED flashes after 30 seconds; all the associations are removed. Release the button.
15°C
20°C
Equipment is "on", Room
temperature higher than 5 ° C,
no heating
10°C
5°C
OFF
Equipment is "on", Room
temperature under 22 ° C,
heating on SSS
Antenna
Button
Removable cover
LED
8