Important Safety Instructions For Battery Packs - DeWalt DW902 Guide D'utilisation

• Disconnect battery pack from tool or place the switch in
the locked or off position before making any adjust-
ments, changing accessories, or storing the tool. Such
preventative safety measures reduce the risk of starting the
tool accidentally.
• Store idle tools out of reach of children and other
untrained persons. Tools are dangerous in the hands of
untrained users.
• When battery pack is not in use, keep it away from other
metal objects like: paper clips, coins, keys, nails, screws,
or other small metal objects that can make a connection
from one terminal to another. Shorting the battery terminals
together may cause sparks, burns, or a fire.
• Maintain tools with care. Keep cutting tools sharp and clean.
Properly maintained tools, with sharp cutting edges are less
likely to bind and are easier to control.
• Check for misalignment or binding of moving parts, break-
age of parts, and any other condition that may affect the
tool's operation. If damaged, have the tool serviced before
using. Many accidents are caused by poorly maintained tools.
• Use only accessories that are recommended by the manu-
facturer for your model. Accessories that may be suitable for
one tool, may create a risk of injury when used on another tool.
SERVICE
• Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by unqualified
personnel may result in a risk of injury.
• When servicing a tool, use only identical replacement
parts. Follow instructions in the Maintenance section of this
manual. Use of unauthorized parts or failure to follow
Maintenance Instructions may create a risk of shock or injury.
Safety Rules for Heavy Duty Flashlights
WARNING: DO NOT OPERATE FLASHLIGHT OR CHARGER
NEAR FLAMMABLE LIQUIDS OR IN GASEOUS OR EXPLOSIVE
ATMOSPHERES. INTERNAL SPARKS MAY IGNITE FUMES.
WARNING: Lens and bulb become hot during use.
• During or immediately after use, don't lay flashlight flat on lens
surface.
• Don't touch lens surface when bulb is lit.
• Handle flashlight with care around any flammable surface.
• If bulb has been lit, let flashlight cool for several minutes
before changing bulb.
• The label on your tool may include the following symbols.
V....................volts
A....................amperes
Hz..................hertz
W ..................watts
min ................minutes
................alternating current
..............direct current
n o ..................no load speed
.................. Class II Construction
.../min............revolutions or reciprocation per minute
..................earthing terminal
..................safety alert symbol
Important Safety Instructions for
Battery Packs
The battery pack is not fully charged out of the carton! First read
the safety instructions below. Then follow charging notes and
procedures.
2