Ubiquiti Networks airMAX Bullet M Mode D'emploi page 32

Bullet M/PicoStation
™
Industry Canada
(NanoStationM/NanoStationlocoM)
This Class A digital apparatus complies with Canadian ICES-003.
To reduce potential radio interference to other users, the antenna type and
its gain should be so chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that permitted for successful communication.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may
cause undesired operation of the device.
This device has been designed to operate with the antennas listed below, and
having a maximum gain of 25 dBi*. Antennas not included in this list or having
a gain greater than 25 dBi are strictly prohibited for use with this device. The
required antenna impedance is 50 ohms.
* Model: NanoStation antenna gain is 25 dBi.
The maximum antenna gain permitted for devices in the bands
5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit; and the
maximum antenna gain permitted for devices in the band 5725-5825 MHz shall
comply with the e.i.r.p. limits specified for point-to-point and non point-to-point
operation as appropriate.
Users should also be advised that high-power radars are allocated as primary
users (i.e. priority users) of the bands 5250-5350 MHz and
5650-5850 MHz and that these radars could cause interference and/or damage
to LE-LAN devices.
30
M/NanoStation
™
M/NanoStationloco
™
M
™