Fasten The Gearmotor And Assemble The Operator - CAME LiftMaster FROG-A 24U Manuel D'installation

INSTALLATION
FASTEN THE GEARMOTOR AND ASSEMBLE
THE OPERATOR
Determine whether your installation is right or left-hand and follow the instructions
accordingly.
1
Remove the white plastic film on the bottom of the in-ground case.
2
Fasten the gearmotor to the bolts on the bottom of the in-ground case using
the nuts and washers provided.
3
Insert the bolt into the motor arm and secure with the nut. This bolt will be
adjusted in a later step when power is applied to the operator (Adjustments
section, page 24).
4
Ensure the rotation pin is greased and insert the gate arm over the rotation
pin.
5
Insert the curved arm between the motor arm and the gate arm.
6
Attach the manual release to the gate bracket. NOTE: Your manual release
may be different. Ensure the manual release is released.
7
Insert the gate bracket into the gate arm.
8
Position the gate between the upper gate hinge and the rotation pin on the
operator.
9
Secure the gate bracket to the gate by tack welding the gate bracket every 1
inch (25 mm) to 1-1/2 inches (38 mm) along the contact surface. Avoid any
welding near the threaded screws.
10
Determine the close position of the gate and install a close end stop
(Figure 2).

FASTEN THE GEARMOTOR AND ASSEMBLE THE OPERATOR

Figure 1: Left Hand Installation
Gate Bracket
Manual Release
Curved Arm
Gearmotor
Figure 1: Right Hand Installation
(Gate in OPEN position)
Gate Arm
Bolt
Motor Arm
Nut
Figure 2
11
(Gate in OPEN position)
Gate Arm
Bolt
Motor Arm
Nut
Gate Bracket
Manual Release
Gearmotor
Curved Arm
90°
Close End Stop(s)
90°