Before An Insulation Test; Preset Test Voltage Selection - Fluke 1550C Mode D'emploi

1550C/1555
Users Manual

Before an Insulation Test

The Tester includes features and functions that let you adapt the test to your
requirements. These features let you:
•
define a test voltage
•
make a ramp test selection
•
set a time limit (duration) for the test
•
measure polarization index (PI)
•
measure dielectric absorption ratio (DAR)
•
measure capacitance
Use these alone or in combination. Set, clear, or account for (as appropriate)
each feature before you start an insulation test. The features are discussed in
this section.

Preset Test Voltage Selection

To make a preset test voltage selection:
1. With the Tester turned on, push  to select TEST VOLTAGE.
2. Push  or  to scroll through the preset test voltage options (250 V,
500 V, 1000 V, 2500 V, 5000 V, and 10,000 V).
The test voltage selection shows in the upper-right of the display.
16
800.561.8187
www. .com
Test Voltage Display
GHH05.EPS
information@itm.co