Operating Instructions; Power Button - komodo SP5736 Manuel De L'utilisateur

Operating Instructions

Power Button

• Press the POWER button to turn ON or OFF the unit.
• When the unit is in ON mode, touch control panel light
will fully light up for 8 sec and then shut down if without
any others operation including remote control.
• When the unit is in OFF mode, the POWER symbol
LED will Semi-bright. When power OFF, unit will be
stopped, if heater is working before power OFF the
unit, fan will have 20 seconds delay to ensure heat will
not be trapped inside the unit.
Each time the fireplace is plugged in, a 5-second fan and
heater will turn on for internal check program.
The unit has a memory function with last settings for
heating level and flame brightness effect, unless the main
power to the unit has been interrupted.
flame Button
• Press the flame button to cycle through the setting as:
Flame Brightness (FL), Flame Color (FC)
flame Brightness Setting
• Press "Flame" key until FL0 / FL1 / FL2 / FL3 / FL4 /
FL5 shown on the display, and then press "+" key or "-"
key to adjust the flame brightness from level 0 to level 5.
flame Color Setting
• Press "Flame" key until FC1 / FC2 / FC3 / FC4 / FC5 /
FC6 shown on the display, and then press "+" key or "-"
key to adjust the flame color.
Setting Color
FC1 Yellow
FC2
Blue
FC3
Yellow + Red
AM
PM
Setting Color
FC4 Yellow + Blue + Red
FC5
Yellow + Blue
FC6
Color Rotation
° F
° C
Timer Button
Timer Setting
• Timer can be adjusted when heater is ON. It can
adjusted from 0 hour (OFF) to 9 hours with 0.5 hour
interval.
• When TIMER is activated, the symbol will be displayed.
• When TIMER digital is 0 H, TIMER function is invalided.
The TIMER symbol will automatically disappear.
• When clock is at the setting mode, hold UP ("+") and
DOWN ("-") keys together to select 12H or 24H mode.
The unit default setting is 24H. The AM or PM symbol
will automatically displayed when the 12H mode was
selected.
• Press the timer key can exit the setting or it will
automatically exit after 8s without any further operation.
Clock Setting
• For clock setting, hold the TIMER key for 5s, hour
display will flashing. Push UP "+" or DOWN "-" key,
Hours setting can be adjusted. Touch the TIMER key
once more, minute display will flashing. Minutes setting
can be adjusted as the same way as hours setting.
Heater Button
• HEATER key is used to control ON/OFF of the heater.
Push UP ("+") or DOWN ("-") key to to scroll through
the pre-set temperature range from 59°F (15°C) to
86°F (30°C), ON & OF (OFF). Heater will turned ON
accordingly to the set temperature. When the ambient
temperature is higher than the set temperature, heater
will automatically turned OFF.
• When the temperature is set at "ON", heater will be
working continuously.
• When HEATER is activated, the heater & temperature
symbol will displayed.
• When the heater is ON, hold the HEATER key for 3
sec; this allow the temperature unit change from °C to
°F or °F to °C. The unit default setting is °F.
13