IntesisHome PA-AC-WIFI-1 Guide D'installation page 5

IntesisHome PA-AC-WIFI-1
®
6. Remove the top hole IntesisHome
7. Connect A-end of the cable (the long one) to the AC CN-CNT connector and B-end (the short one)
to the IntesisHome
Insert the cable through the IntesisHome
(see Figure3).
Important: Use only the cable attached. Extending or shortening the connecting cable included
with the interface may cause it to malfunction. Keep the connecting cable as far away as possible
from electrical wires and ground wire. Do not bundle them together.
Important: Both connections should be kept inside the AC unit and the IntesisHome
respectively.
8. Put on/close the front grill of the indoor AC unit.
(See Panasonic's AC unit's installation manual)
9. Close the IntesisHome
10. Plug the AC unit to the power supply line.
If connection with the AC has been successful, the internal LED (see Figure 2) will turn on (and
start flashing) and the IntesisHome
4.2 Placement
Important: Avoid placing the
device next to metal surfaces.
IntesisHome device needs to be placed next to the AC unit in a vertical position (see Figure 4).
®
Recommendations:
1. Use the top hole in the back of the IntesisHome
(See Figure 1)
2. In order to place the device, use the holes in the back of the device to screw it or a double side
tape to fix it. (See Figure 1)
cable cover (see Figure 1 and Figure 3)
®
device K1 connector (see Figure 3).
®
®
lid again.
®
device LED will turn on and will stay steady GREEN.
®
Figure 4.- IntesisHome
®
top hole cable to correctly set the connection cable
Important: When possible, try to check Wi-Fi
coverage in the installation location. Good Wi-Fi level
is strongly recommended.
device and AC placement
device to insert the cable into the AC.
®
INSTALLATION GUIDE
device
®
EN
5