Power Off - Livall C20 Mode D'emploi

Power on
Hold the button at the back
of the helmet for 2 seconds,
then the LED taillight will blink
for 10 seconds after the helmet
is powered on, which means
the helmet automatically enters Hold 2 seconds
adaptive warning light mode.
Remark: When powering on, you could check the remaining battery level of the helmet by the number of tail lights,
all the 7 lights on indicates full power.

Power off

Hold the button at the back of the helmet for 2 seconds until all the LED taillight turns off.
Lighting Mode
lighting mode: After the helmet is power on, press the button for a second to switch the three lighting modes in
order. 1.adaptive warning mode A;2.adaptive warning mode B;3.keep warning light always on.
Adaptive Warning Lighting
2 seconds after power on, press the button (less than 1 second), the helmet will enter the adaptive warning
lighting mode. In daytime or in a bright environment, only the central LED will keep flashing, other LED will turn
off automatically. While at night or in a dark environment, the whole taillight will keep flashing automatically.
3