Settings Menu: Change Language - Mark OptiTherm Livret Technique

For example:
The measured temperature is 18°C, the screen display on the OptiTherm shows 20°C. The diffe-
rence in this example is therefore 2°C too high  the correction value must then be set at -2°C.
You can change this following the image below:
back to main screen
2x
ESC
Settings
Fan high/low
Burner high/low
Select Temperature sensor
Calibrate
Language
select
• Now with the  and  button, select Calibrate Thermostat and then push the OK button
• Only applicable when an external sensor is also used.
• With the  and  button, select Sensor and then push the OK button
• Only applicable when an external sensor is also used.
• Now with the  and  button select the air heater (1 to 8) from where the external sensor
must be calibrated and then push the OK button.
• With the  and  button, select Deviation and then push the OK button
• With the  and  button set the desired value and confirm this with the OK button.
• When you have finished with the changes you leave the menu item by pressing the ESC button
and you go back to the settings menu.
• Now select another item to change or to go back to the user menu by pushing the ESC but-
ton. Push the ESC button again to go back to the main display.

5.12 Settings menu: Change language

If you want to change the chosen language you can change this by going to the settings menu and
changing the language.
To change the chosen language you follow the image below.
back to main screen
2x
ESC
Settings
Fan high/low
Select Temperature sensor
Calibrate
Language
Summer/wintertime
select
18
ESC
Calibrate
Sensor Room Control
Deviation 0.0 K
OK
select
ESC
Language
English
English
Nederlands
Deutsch
Français
OK
select
OK
con rm selection
ESC
Calibrate
Sensor Room Control
Deviation 0.0 K
OK
modify
OK
to next digit