Product Overview; Wired Remote Control - Chauvet DJ HURRICANE 700 Manuel De Référence

Product Overview

Permanently
Wired Remote
Power In
Fuse
Holder
AC Power
This product has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC,
50 Hz, depending on the specific model.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Fuse Replacement
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.

Wired Remote Control

Trigger the Hurricane 700 using the included wired remote. The LED indicator on the remote indicates when the fogger
has reached the required operating temperature. Press the button on the remote to output fog. The length of the wired
remote cable is 6 ft (2 m).
Mounting
Before mounting this product, read the
Mounting Diagram
Safety Cable
(such as CH-05 from
Chauvet)
Mounting Bracket
Feet for Floor
Mounting (x4)
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean your Hurricane 700. Make
sure you use FCQ regularly, no longer than 90 days between cleanings, to increase the life of your
product.
While operating the Hurricane 700, make sure there is adequate fog fluid in the machine to prevent
pump and heater damage. When the fog fluid level becomes low, simply add more fog fluid to
continue using the Hurricane 700.
Hurricane 700 QRG Rev. 5
QUICK REFERENCE GUIDE
Nozzle
Fluid Level
Indicator
Safety Notes.
Fluid Tank
Mounting Clamp
(such as CLP-10 from
Chauvet)
Bracket Adjustment
Knob (x2)
EN
2