Uninstallation; Hardware Installation; Hardware Installation For Pci Card - Atlantis NetFly UP WN Mode D'emploi

3.2 Uninstallation

To uninstall the Wireless USB/PCI Adapter/Adapter, go to the Control Panel of your
system.
 Open the Add/Remove Programs.

Select the Ralink Wireless Lan Card in the Add/Remove Programs and
then click on the Remove.
 Click on Remove ALL [or Overwrite the older version install without
remove].
 Then chose Yes, I want to restart my computer and click Finish.
Now You can remove the Adapter/Card.

4. HARDWARE INSTALLATION

4.1 Hardware Installation for PCI Card

The setup of the Wireless LAN Card can be performed using the following steps:
 Shut down the computer, unplugs its power cord, and remove the chassis cover.
 Insert the contact edge of the NetFly card into the connector of any available
PCI Bus Master expansion slot. Press the card firmly into the connector such that
the card's contacts are fully seated in the connector.
 Install the bracket screw and secure the card to the computer chassis.
 Visually inspect the PCI Adapter and make sure that it is fully plugged in to the
PCI slot.

Cover the computer's chassis.
 Switch computer power on.
The OS will start an automatic hardware discovery procedure in order to find and
install the best driver available for the device.
Make sure that there is a well environment that there is no
much intrusion to have a better connection.
53