Giordani PEGASUS PLUS ISOFIX Guide D'utilisation page 14

with the ISOFIX, please operate as fol-
lowing:
25. Extend the ISOFIX connectors and fix
it into the ISOFIX anchorages until you
hear an audible sound "click".
Fasten the car belt. Details please refer
to the abovementioned instructions for
the car belt installation for group 2/3.
CARE INSTRUCTIONS
Removing the 5-point harness system
and cover
26.
Open the snap buttons from the back
of the car seat, then raise the cover as
shown in the picture.
27. Push down the adjustment device and
pull the harness strap out the strap
yoke from other side to unlock it.
28. Pull the shoulder strap axle out, un-
tie the gap of the shell Then unite the
shoulder strap and pull it out from the
harness slot.
29. Loosen the bottom part of the cover
and pull the belt clip through the belt
clip slot. Then pull the buckle clip
through the buckle clip slot.
30.
Remove 5-point harness system then
remove the headrest cover and the
shell cover.
Refitting the 5-point harness system
and cover
31. After washing, place the cover on the
shell.
32. Loosen the bottom part of the cover
and pull the belt clip through the belt
clip slot. Then pull the buckle clip
through the buckle clip slot.
33.
Put the end of the shoulder strap
through the harness slot , fix into
shoulder strap axle, and lock the
shoulder strap axle to the seat shell .
34.
Also put the end of the harness strap
through the harness strap slot and
shell, fix into the strap yoke, make sure
the seat straps can not be rotated.
35.
Close the buckle, then fasten the cov-
er all around. Check that it works!
CLEANING
Please be sure to use only original seat
covers, as the seat cover is important to
the proper functioning of the system. Re-
placement seat covers are available from
your retailer and or at branches.
The child seat must not be used without
the seat cover.
The seat cover should not be replaced
with any other than the one recommend-
ed by the manufacturer, because the
cover constitutes an integral part of the
restraint performance.
The cover can be removed and washed
with a mild detergent using the washing
machine's cycle for delicate items (30°C).
Please observe the instructions on the
washing label of the cover. The colours of
the cover may fade if washed at more than
30°C. Do not spin, and never tumble dry in
an electric clothes dryer (the fabric may
separate from the padding).
The plastic parts can be cleaned using
soapy water. Do not use harsh cleaning
agents (such as solvents).
The harness can be removed and washed
in lukewarm soapy water.
Caution! Never remove the buckle tongues
from the straps.
MATERIALS
Cover: 100% Polyester
Frame: Polypropylene
26
SIZES
L: 69 cm;
H: 63 cm;
D: 45 cm.
CHECKLIST
For safety's sake read through this check-
list before you set off.
Check that the harness belt system fits
properly and tightly around your child and
that the shoulder belts are at the correct
height.
Check regularly that the belt in the baby
car seat is not damaged. If it is damaged do
not use your product in any circumstances
and contact your supplier or importer (see
address list in the service card).
Check that you have secured your baby car
seat with the seat belt.
If you have any questions, please contact
your supplier.
• Make sure that you have the following
details to hand:
• Serial number underneath on the service
card.
• Mark and type of vehicle and seat on
which the baby car seat used.
• Age and weight of your child.
WARNINGS
• FAILURE TO OBSERVE THE AS-
SEMBLY INSTRUCTIONS PROVID-
ED BY THE MANUFACTURER MAY
BE DANGEROUS FOR THE SAFETY
OF THE CHILD.
• This is a child restraint system ap-
proved Regulation No.44,04 stand-
ards, for three different types of instal-
lation:
- using the ISOFIX and Top Tether an-
choring systems, the device is clas-
sified as a "Universal" for Groupl(9-
18kg), which under more stringent
conditions than those that were ap-
plied to earlier designs which do not
carry this notice.
- using the child car seat without the
optional ISOFIX, with the 3-point car
seat belts, the device is classified as
a "Universal" device, far Group 2&3
(15-36kg).
- using the optional ISOFIX, with the
3-point car seat belts, the device is
classified as a "Semi-Universal" de-
vice which is compatible for use on
the vehicles indicated in relative "List
of approved vehicles', for Group 2&3
(15-36kg).
• A correct fit is likely if the vehicle man-
ufacturer has declared in the vehicle
the handbook that the vehicle is ca-
pable of accepting a "Universal" child
restraint for this age group.
• To use the UNIVERSAL ISOFIX SYS-
TEM, it is approved to Regulation No.
44, 04 series of amendments for gen-
eral use in vehicles fitted with ISOFIX
anchorages systems. It will fit vehicles
with positions approved as ISOFIX
positions (as detailed in the vehicle
handbook), depending on the catego-
ry of the child seat and of the fixture.
• The mass group and the ISOFIX size
class for which this device is intended
is: ISOFIX size class B1.
•
If in doubt. consult either the child
restraint manufacturer or the retailer.
• Read this instruction manual carefully.
• The correct fitting of the ISOFIX and
Top Tether anchoring systems or
3-point belt is of vital importance for
the safety of your child.
• For the future use of the seat, it is im-
portant that you keep the instruction
manual carefully.
• Never leave your child unattended in
27