Before Initial Start-Up; Installation Instructions - Heatwave Pro Line 300 Mode D'emploi

12. Children under 3 must be kept away from the device unless they are continuously monitored. Children aged between 3 and 8 may
only switch the device on and off (using the switch or thermostatic controller) if they are supervised or have been instructed on how
to use the device safely and have understood the hazards resulting from this, with the prerequisite that the device is placed or
installed in its normal usage position. Children aged between 3 and 8 must not plug the device into the mains, regulate the device,
clean the device and/or carry out user maintenance. WARNING: Certain parts of the product can become very hot and cause burns.
Particular care must be taken if children or people in need of protection are present.
1 3. Do not try to repair the infrared-heating element, the power cable cannot be replaced and must always be returned to the
manufacturer for repairs. WARNING: If heating elements have a glass surface, the device must not be used if the glass is damaged!
14. WARNING: This unit is not equipped with a device for controlling room temperature. The heating unit may not be used in small
rooms occupied by persons not able to leave without assistance, unless there is continuous monitoring.

BEFORE INITIAL START-UP

Read the safety instructions and the manual before use! Check the infrared heating element for visible damage and whether the mains vol-
tage is in accordance with the voltage information on the type plate (backside). If you notice damages on the element, do not use it - contact
your specialist dealer.
We recommend you not to throw away the original package of the device. Store the original package for possible transport.
START-UP
The infrared heating element must be installed according to the following installation instructions, connected to the electric net and
controlled with an EU-compliant control.

INSTALLATION INSTRUCTIONS

Before you mount a heating, you have to secure the carrying capacity (structural analysis/temperature resistance)! You can find the weight of each
panel on the cover of the instruction manual. Do NOT mount glass- or mirror heatings on the ceiling! The drilling dimensions can be found in the
enclosed assembly instructions. Precise drilling is absolutely essential. It is advised to ask a second person for help.
If you mount the heating on the ceiling read the additionally attached installation instructions carefully!
Check if the supplied screw anchors are suitable for the existing building structure. The holding and fixing material provided is suitable for brick or
stone walls. On other types of wall or masonry (as e.g. Rigips, wood,..) please use suitable holding and fixing material.
If you hit reinforcement steel in the ceiling while drilling, then deflect the drill. The panel should be repositioned to re-align all the holes. Thread the
dowels into the holes, fix the screws in them and mount the heating. Attention: 20mm difference by locking in place!
After mounting the panel, please check if ALL screws are exactly inserted into the brackets. You can take a mirror for places which are difficult to
access.
After checking that all the screws are in the brackets, you can tighten the screws equally.
No assembly for all mobile heating elements (standing models, pillars etc.) – they can be plugged into a socket and are ready for operation.
The heating elements may not be moved by pulling the power cable. The heating element should only be moved by taking the whole column.
ATTENTION: Allow the device to cool down before you move it!
Heatwave takes no responsibility and liability for any damages resulting from the negligence by installation.
INSTRUCTION MANUAL
- 9
EN - 9