Electrical Connection; Cleaning And Care; Eg- Declaration Of Conformity - Heatwave Pro Line 300 Mode D'emploi

HE AT WAVE

ELECTRICAL CONNECTION

The infrared heating element is provided with a mains plug. After having finished the assembly, connect to a 230 Volt, 50 Hz socket. Room
temperature controller can be included in the system by adapter plugs (socket thermostat) or in case of a fixed connection, consult an instal-
lation specialist to install a control - taking into account the appropriate standards and norms of the country
concerned. If a stationary device is not equipped with a mains cable and a plug or another means of disconnecting the mains, which has a
contact opening width on each pin in accordance with the conditions of overvoltage category III for complete disconnection, the instructions
must mandate that a disconnection device of this type must be installed in the fixed electrical installation in accordance with the installati-
on regulations.

CLEANING AND CARE

Before cleaning, always disconnect the main power plug or switch without tension. Once a year before the heating season, free the heating
from dust and dirt and check the safety plates and the screws. If necessary, retighten them. To clean you should use a smooth and damp cloth
and some dish detergent. Never clean the infrared heating element and the power supply cables under running water, nor submerse in water.
Do not use harsh, abrasive or easily inflammable detergents.

EG- DECLARATION OF CONFORMITY

Heatwave B.V. declares that this device is in conform with the EMC regulation EMV 2014/30/EU and
with the Low-Voltage Directive 2014/35/EU.
DISPOSAL
The infrared heating element has to be disposed separately of general household waste at government places provided for this purpo-
se. You can obtain detailed information for disposal at the specialist dealer where the product was purchased.
designates that failure to comply with these guidelines can endanger your health and/or the function of your infrared heating
element.
designates, that the infrared heating element is conform to the European Directive 2012/19/EU.
The appropriate disposal and collection of scrap equipment serve to prevent potential environmental and health damages.
They are a requirement for the re-use and recycling of used electric and electronic devices.
designates further information and tips.
designates that the infrared heating element must not be covered.
10 - 10 - EN