Reer PIA Notice D'utilisation page 13

Renewed boiling becomes possible only after the automatic switcho mecha-
nism has cooled down su ciently. This may take a couple of minutes, depending
on the operating and surrounding temperatures.
Drying protection: In case your device is in operation with too little or no water,
the drying protection prevents overheating, but doesn´t turn it o completely. The
device must be turned o manually by all means! Let it cool down (10 mins) before
re lling. After cooling down the device is ready for operation.
Always unplug rst. When the heating bowl has cooled o , it can be wiped out
with a damp cloth. For decalcifying the appliance use commercially available uid
Decalci ers. Follow the respective instructions for use! Limescale can also be dissol-
ved by a vinegar-water solution (equal parts household vinegar and water) which
is brought to boil brie y. If there is a lot of limescale, the above mentioned process
must be repeated. Do not leave the heating bowl unattended as the vinegar-water
mixture can foam over. Leave the solution in the heating bowl for a few moments
longer after brief boiling and then pour it out. Wipe out the heating bowl after the
de-calcifying, an repeat the evaporation process with clean water to neutralize the
odor of vinegar. Do not use strong de-calci ers or sourcing agents nor scratch with
pointed objects. The spout drainage is dishwasher safe.
Should the kettle not be functioning properly or should unexpected malfunctio-
ning occur, we kindly ask you to:
1. First thoroughly read the respective section of the instruction
manual once again.
2. Afterwards please try to nd the error with the help of the following mal
function chart.
3. Should you not be able to solve the problem, we kindly ask you to contact
your specialist dealer.
Cleaning and attendance
- 13 -
Operation
NOTE
SAFETY
GB
ATTENTION