System Test - GYS BTW 300 Mode D'emploi

Translation of the original instructions
BATTERY TEST OR BATTERY START/STOP TEST
1. Prepare the test by selecting
the type of battery, the nominal voltage
and the defined capacity. (move your
finger towards the top to scroll through
the proposals)
2. Select «start test».
Confirm that the battery is charged.
Result
BATTERY OK
OK FOR RECHARGE
CHARGE & TEST
TO BE REPLACED
BATTERY DAMAGED, REPLACE

SYSTEM TEST

1. In the menu select «Charging System»
2. Configure the test by selecting the battery type, nominal voltage and defined capacity (slide your finger up to scroll through the
proposals).
3. Select «start test». To return to the previous screen press «<» during the process.
4. Follow the instructions of the tester :
5. The test report is displayed. Press «send test results by email/message»
10
BTW 300
3. The test report is
displayed.
4. Press «send test
results by email/mes-
sage» and select the
application.
Screen display
XX %
The battery is in working order.
GOOD AND PASS
XX %
Battery in good condition but low state of charge.
GOOD & RECHARGE
XX %
Charge the battery and perform the test again.
RECHARGE & RETEST
XX %
The battery is nearing the end of its life.
A replacement should be considered.
TO BE REPLACED
XX%.
A problem at the cell level is observed (short cir-
DEFECTIVE BATTERY :
cuit.....). Replace the battery.
TO BE REPLACED
EN
Analysis