DuPont MODULO CONFORT Guide D'utilisation Et D'entretien page 13

GENERAL ASSEMBLY OF THE WHEELCHAIR
Your Modulo Comfort Wheelchair will be delivered to you in two boxes. The contents of the boxes are clearly marked for easy assembly
TO OPEN UP THE METAL FRAME OF THE WHEELCHAIR
Take the folded frame out of the box. To open the frame up push down with both hands on ONE of the two
horizontal metal tubes of the seat. Do not exert any pressure on both sides of the chair at the same time.
PUTTING THE SEAT INTO PLACE (see photo I and IA)
Photo 1
A
Slots
Guides of base seat
PUT THE BACKREST INTO PLACE (see photo 2)
Photo 2
PUT THE ARMRESTS INTO PLACE
(see photo 4 )
Put the vertical tube support of the
armrest into the lower bracket
above the wheel. Following this
procedure swing the armrests into
H
F
place. See & for the parts.
ASSEMBLY AND ADJUSTMENT OF THE LEGRESTS
PLACE THE LEGRESTS INTO THE FRAME
Photo 5
T
C F
MODULO
COMFORT
Photo 1A
Front seat
adjustment
Insert the four threaded knobs on
the back of the chair into the four
locating brackets on the back of
the frame.
Tighten the knobs to lock the
back in place.
Photo 4
H
F
(see photo 5)
T
Position the tube on the
C
cylindrical support indi-
cated on photo 5. Turn the
legrest when inserted a
quarter of a turn towards
the chair to lock the legrest
C F
with parts and .
- See photo 1(seat base) See photo 1A (Identification of the slots on the hori-
zontal tubes)
- Select the seat position you want (4 options)on the front of the seat base (1A)
- Put the black positioning knobs in the required slots
- Make sure the back metal upturned hooks of the seat base are locked into posi-
tion behind the metal horizontal tubes and that they are securely fitted by sliding
the seat base backwards.
- Fit the seat cushion onto the seat base deepest part at the back. Velcro will keep
the cushion in place
PUT THE HEADREST INTO PLACE (see photo 3)
Photo 3
L
K
ADJUSTING THE ARMRESTS
(see photo 4 Bis)
Photo 4bis
H
G
Adjusting the legrests
Photo 6
E
- Slide the metal tubes in the
backrest after unscrewing the
K
toothed wheel .
- To adjust the height of the hea-
drest use the toothed wheel
- To adjust the incline of the hea-
drest use the toothed wheel
Detach the armrests from the
wheelchair. Unscrew the toothed
G
and pull out the part
wheel
J
. Slide the armrest to the correct
J
height (and release
G
part . Place the armrest back
into the chair as above.
J
To change the incline of the legrest
E
Unlock the lever (fold down
without unscrewing)
Position the legrest to the requi-
E
red angle. Lock . When adjus-
ting the angle of the leg rest be
careful that you do not trap your
hand or fingers in the hinge.
K
.
L
.
) Tighten up
13