Elinchrom ELB 500 Manuel D'utilisation page 7

User Manual
This device complies with Part 15 of the FCC. Operation is subject
to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
EN
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into a power outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/television technician
for help.
Modifications: Changes or modifications not approved by
ELINCHROM LTD can void the user's authority to operate the
equipment.
6