Fcc Notice - Mettler Toledo IND231 Mode D'emploi

© METTLER TOLEDO 2013
No part of this manual may be reproduced or transmitted in any form or by any means, electronic or mechanical,
including photocopying and recording, for any purpose without the express written permission of METTLER TOLEDO.
U.S. Government Restricted Rights: This documentation is furnished with Restricted Rights.
Copyright 2013 METTLER TOLEDO. This documentation contains proprietary information of METTLER TOLEDO. It may
not be copied in whole or in part without the express written consent of METTLER TOLEDO.
METTLER TOLEDO reserves the right to make refinements or changes to the product or manual without notice.
®
METTLER TOLEDO is a registered trademark of Mettler-Toledo, LLC. All other brand or product names are trademarks
or registered trademarks of their respective companies.
METTLER TOLEDO RESERVES THE RIGHT TO MAKE REFINEMENTS OR CHANGES WITHOUT
This device complies with Part 15 of the FCC Rules and the Radio Interference Requirements of the Canadian
Department of Communications. Operation is subject to the following conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her expense.
Declaration of Conformity is located on the documentation CD.
The majority of our products fall within categories 8 and 9. Those categories currently do not fall within the scope

of the Directive 2002/95/EG (RoHS) of January 27, 2003. If our products are intended for use in other products
which themselves fall within the scope of the RoHS Directive, compliance requirements have to be separately
negotiated contractually.
Those products which fall within categories 1-7 and 10 will be in compliance with the EU RoHS Directive from no

later than July 1, 2006.
If it is not possible for technical reasons to replace any non-RoHS-compliant substances in any of the above

products as required, we plan to inform our customers in a timely manner
We do not make direct use of harmful materials such as asbestos, radioactive substances or arsenic compounds.
However, we purchase components from third party suppliers, which may contain some of these substances in very
small quantities.
COPYRIGHT
NOTICE.

FCC Notice

RoHS Compliance Statement.
Statement regarding harmful substances