Lincar 700 Serie Manuel page 22

Replacing the pilot burner nozzle
Unscrew screwed-on cap (Ref. 1), remove the nozzle and
•
replace it with one that is suitable for the type of selected
gas (see Tab. 3).
Refit the screwed-on cap.
•
Use a foam product to check that the cap does not leak.
•
Tab. 3
Methane Butane/Propane
G20 G30/G31
27 14
Minimum adjustment
Remove the knob and the front cover.
•
To regulate the minimum of burners with the by-pass screw as indicated on figure (tab.4)
•
for BUTANE/PROPANE gas (G30/G31) the screw must be screwed till the bottom;
•
By-pass
Tab. 4
Methane
By Pass
G20
kW 8-3,6 Adj.
kW 11-5,5 Adj.
After the necessary transformation and substitution, reassemble precisely every removed
•
parts for testing to come back to original situation.
To apply on the technical plate, in the appropriate space, the complementary little plate
•
with the characteristics of new gas type installed.
Test for leaks on the gas circuit.
•
Σ
Before delivering the appliance to the user:
Check that operates correctly;
•
Instruct the user at the correct use.
•
for METHANE gas (G20)
place the burner knob to regulate, in minimum position
with the burner light up, unscrew anticlockwise the by-
pass screw to obtain a minimum steady flame. The burner
flame must remain ignited also in the passages from
maximum to minimum without cause backfires.
After the regulation seal the by pass with varnish.
•
Butane/Propane
G30/G31
1 mm
1,3 mm
22/64
Complementary little plate
mod. G15
1